<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html><head><title>hmake interactive</title></head>
<body bgcolor='#ffffff'>
<table><tr><td width=500>
<center><h1><em>hi</em> - hmake interactive</h1></center>
<hr>
<p>
<em>Hmake interactive</em>, or <em>hi</em> for short, is an
interpreter-like environment that you can wrap over any common Haskell
compiler to achieve an interactive development style.
<p>
It deliberately looks and feels a lot like the <em>Hugs</em>
interpreter. The difference is that you get real compiled code,
compiled by your favorite compiler - you can even change compiler on
the fly, to check your code's portability!
<p>
Of course, one of the reasons people prefer Hugs over a compiler is
that <em>Hugs</em> generates runnable code very quickly compared to,
say, <em>ghc</em>. But all compilers are not equal - for instance,
<em>nhc98</em> is pretty fast at generating code. On a
500Mhz Pentium, <em>hi</em> compiles an expression
typed at the command-line in about one second with <em>nhc98</em>.
And if you compare compile time with running time, <em>nhc98</em>'s
compiled code runs between 3-15 times faster than <em>Hugs</em>,
so you can easily end up with a net gain.
<p>
An even bigger potential advantage of <em>hi</em> is that it uses a
smart recompilation strategy. Big programs are the ones on which you
would most like to use a compiler, for the benefit of speedy code.
However, in big projects, compile times are long, so you really
only want to recompile the modules you have edited and those which
depend on them. Writing Makefiles is tedious and error-prone, so
<em>Hugs</em> is often seen as an easier alternative. But because
<em>hi</em> is just an interface to the standard <em>hmake</em>,
you get the benefit of its recompilation analysis to rebuild only
what is necessary, so you can reduce compile-times significantly,
whilst still achieving full compiled-code speed, and what's more,
you also have the <em>Hugs</em>-like ability to test small expressions
at the command-line.
<p>
To use <em>hmake interactive</em>, just grab, build, and install
<em>hmake</em>, then type <em>hi</em>. The commands available are
described in <a href="hi-commands.html">hi-commands.html</a>. There
is a <a href="lineedit.html">simple line editor</a> in <em>hi</em>
to allow you to edit expressions as you type them.
<p>
If you want to know a little bit more about <em>hi</em>, there are
two draft documents describing its implementation.
<a href="ftp://ftp.cs.york.ac.uk/pub/malcolm/hw00-draft.html">
A literate script.</a>
<a href="ftp://ftp.cs.york.ac.uk/pub/malcolm/ifl00-draft.html">
A draft paper.</a>
<hr>
<p>
The latest updates to this software are available on the WWW from
<a href="http://www.haskell.org/hmake/">
<tt>http://www.haskell.org/hmake/</tt></a>
(<a href="http://www.cs.york.ac.uk/fp/hmake/">
<tt>http://www.cs.york.ac.uk/fp/hmake/</tt></a>)
<p>
Information last updated: 2003-06-23<br>
<a href="http://www.cs.york.ac.uk/fp/">
York Functional Programming Group</a><br>
[email protected]
</td></tr></table>
</body></html>
|
